Electrical

Does anyone have a good illustration of how the WIPAC IGN/EMG & High/Low rotary switches work?

Hi guy's
I'm wanting to do away with the headlight switch on my dominator and replace it with a off/on/on flick switch can anyone advise me how to go about this please 

Taken the mag to bits . It does spark but feels a little rough . Shimming too tight , will need a thicker end shim . Also no carbon brush under the points plate , something missing?? Or does the manual mag not have one ?

Hi all I was looking at my ES2 over the weekend unfortunately the headlight didn't work iv taken the glass out and found that on the bulb element only one wire was connected there are a few wires in the headlamp that are not connected to anything

Hi Folks I have a standard lucas dynamo on my 16h which was professionally re conditioned about 8 years ago. When I spin it up it happily produces 18 volts at the D and F.

My Mag has no spark so it's now off and on the bench. 
can anybody recommend the best place to send it too? 

Regards
Craig

My 650 SS PR would have had an auto advance mag or a fixed advance . I have both types of mags , but would prefer the K2FC as it would appear to be in far better condition .Is it a straightforward parts swap ?

Afternoon

There is no retaining clip on my light switch it looks like it has been stuck in with mastic.

To get the light switch out I take it the switch breaks apart either side of the headlamp shell?

Hi. I am putting my 73 750 back together but cannot remember the routing of the wiring to the ignition switch. The photo shows what I have done but it doesn't look right. There was a small K&N aircleaner before which would have been easier.

Before, I do the timing, could someone tell me how I initially get the right position on the timing chain for a Distributor on a 99 Dominator please.