Singles

Hello, I am looking for this front hub, or can you give me an address if someone makes one?

Hi All, I am searching to find a supplier for an engine and gearbox sprocket for a 1929 Norton Model 18. The engine shaft taper on these early bikes is smaller than the later machines and the Sturmey Archer gearbox spline is also smaller.

Hello all,

Recently, I bought a set of Model 50 crankcases. Am I right these are from a late alternator model and am I looking at a rev counter drive?

Cheers,

Tim

In answer to Stu Rodgers question about a strange cambox in Roadholder 447 I submit the following.

Kickstart return spring!

Good evening all, I'm hoping some light can be shed on an issue I currently have. I'm attempting to fit a new kickstart spring, the old one had snapped and appears to have a longer tang welded on.

Hello Folks

Hi all I'm new to NOC and to Norton ownership. I purchased a 59 model 50 last year. I did a couple of hundred miles and found that the clutch adjustment at the amc box end was at its limit and still had 1/2 inch of play at the lever end!

Has anyone done this conversion ? Need to know of advantages and disadvantages and any likely issues 

Good afternoon,
I want to fit a side stand to my ~1930 framed model 18. The club lists a bolt on stand part number E2/1014 for years 1945 to 1957. What has to be done to adapt it for my older bike?

Thanks

John

What sort of filter would have been an original fitment. Would have to fit a 376 , so possibly a later model .