I am rebuilding a 250 Jubilee and am nearly at the point where I can give it a kick and see if I can start her up again, after what I believe to be a very long time.
My next job is to ensure the oil distribution is correct, I intend fitting new hoses throughout, I have been trying to locate a schematic showing the pipes and direction of flow. There is a thread on a NOC Forum from 2014 identifying a Roadholder archive where the pipes are referenced with sizes and an attachment, but maybe due to the passage of time the attachment isn't available.
Any help much appreciated
Andy
Read the Lightweight Compendium....
- Log in to post comments
Thank you Andy for the post…
Thank you Andy for the post and Dennis for the reply. I did not know (or more likely had forgot) about the Compendium. Question, is there a way to print off? I have tried but it will not let me. I know I can print of pages using print screen and pasting but that's a pain and it would be useful to print off pages for use in the workshop. Or can you buy? Cannot see in the NOC Shop.
Regards Glenn
- Log in to post comments
Jubilee Oil Pipes
Glen:
What an amazing source of information that is , relatively new to the club and never seen it before,
Brilliant thank you,
Andy
- Log in to post comments
Read the Lightweight Compendium in the Technical Section, page 68. You will need to load the electronic document. This is a useful source of information.
Dennis